Can-Am Defender Automatic Reverse Light with Auxiliary Output 2016+
Can-Am Defender Automatic Reverse Light with Auxiliary Output 2016+
Couldn't load pickup availability
Starting at $139.99
Automatic Reverse Light with Auxiliary Output for Can-Am Defender - no switches required!
*Note - The Auxiliary Output function will only work with the keypad option (see picture)
Easy Installation. Fully automatic turns back-up light ON when transmission is shifted into reverse and OFF when shifted out, no additional switches or brackets required.
Plug and Play design - complete wire harness, controller and no programing
Manual Override function: The back-up lights can be turned on without the vehicle needing to be shifted into reverse. Light manually overrode/operated by shifting to Neutral and holding the brake pedal down for 2 seconds, repeat the steps to put the lights back into automatic mode.
Auxiliary Output Control: Perfect for operating forward facing LED Lights, Rock Lights, or any 12v accessory without needing to install an additional switch. Auxiliary output is turned ON by pressing the trip button two times within 1 second, repeat the process to turn OFF. Auxiliary output will turn off automatically when the ECU powers off, no more dead battery from forgetting to turn your lights off!
Will work with any standard 12 volt light or accessory.
Installation Manual for Auxiliary Output 2-Seat with Factory Wiring without Lights
Installation Manual for Auxiliary Output 4-Seat with Factory Wiring without Lights
Installation Manual for Auxiliary Output 2-Seat without Factory Wiring without Lights
Installation Manual for Auxiliary Output 4-Seat without Factory Wiring without Lights
Installation Manual for Auxiliary Output 2-Seat with Factory Wiring with Lights
Installation Manual for Auxiliary Output 4-Seat with Factory Wiring with Lights
Installation Manual for Auxiliary Output 2-Seat without Factory Wiring with Lights
Installation Manual for Auxiliary Output 4-Seat without Factory Wiring with Lights
NOTE: If existing factory wiring is available and unused choose this option, it reduces installation time significantly (models with factory installed A/C - running additional wires thru the firewall and behind the evaporator is extremely difficult! - Only 2 of the 4 wires is needed for installation.)
NOTE: If ordering without the Lights and Brackets option, harness is shortened to 88-inches and includes a single light plug, not two. Also includes one two-pin light connector to pin onto your non-Sam's Backup Light accessory. Refer to the wiring diagram included with the pictures on this page. Extensions to convert to dual lights can be obtained on our website under "accessories --> wire & connectors."













-
Hassle-Free Exchanges