Can-Am Defender Automatic Reverse Light 2016+

Starting at $99.99

Automatic Reverse Light for Can-Am Defender - no switches required!

Easy Installation. Fully automatic turns back-up light ON when transmission is shifted into reverse and OFF when shifted out, no additional switches or brackets required.

Plug and Play design - complete wire harness, controller and no programing

Manual Override function: The back-up lights can be turned on without the vehicle needing to be shifted into reverse. Light manually overrode/operated by shifting to Neutral and holding the brake pedal down for 2 seconds, repeat the steps to put the lights back into automatic mode.

Will work with any standard 12 volt light. 

Installation Manual for 2-Seat with Factory Wiring without Lights

Installation Manual for 4-Seat with Factory Wiring without Lights

Installation Manual for 2-Seat without Factory Wiring without Lights

Installation Manual for 4-Seat without Factory Wiring without Lights

Installation Manual for 2-Seat with Factory Wiring with Lights

Installation Manual for 4-Seat with Factory Wiring with Lights

Installation Manual for 2-Seat without Factory Wiring with Lights

Installation Manual for 4-Seat without Factory Wiring with Lights

NOTE: If existing factory wiring is available and unused choose this option, it reduces installation time significantly (models with factory installed A/C - running additional wires thru the firewall and behind the evaporator is extremely difficult! - Only 1 of the 4 wires is needed for installation).

NOTE: If ordering without the Lights and Brackets option, harness is shortened to 88-inches and includes a single light plug, not two. Also includes one two-pin light connector to pin onto your non-Sam's Backup Light accessory. Refer to the wiring diagram included with the pictures on this page. Extensions to convert to dual lights can be obtained on our website under "accessories --> wire & connectors."